Authentic NSE6_FWF-6.4 Dumps With 100% Passing Rate Practice Tests Dumps
Fortinet NSE6_FWF-6.4 Real Exam Questions Guaranteed Updated Dump from TorrentExam
NEW QUESTION # 15
Refer to the exhibits.
Exhibit A
Exhibit B
The exhibits show the diagnose debug log of a station connection taken on the controller CLI.
Which security mode is used by the wireless connection?
- A. WPA2 Enterprise
- B. WPA3 Enterprise
- C. Open, with radius MAC filtering
- D. WPA2 Personal and radius MAC filtering
Answer: D
NEW QUESTION # 16
Which two statements about distributed automatic radio resource provisioning (DARRP) are correct? (Choose two.)
- A. DARRP measurements can be scheduled to occur at specific times.
- B. DARRP performs continuous spectrum analysis to detect sources of interference. It uses this information to allow the AP to select the optimum channel.
- C. DARRP requires that wireless intrusion detection (WIDS) be enabled to detect neighboring devices.
- D. DARRP performs measurements of the number of BSSIDs and their signal strength (RSSI). The controller then uses this information to select the optimum channel for the AP.
Answer: B,C
Explanation:
DARRP (Distributed Automatic Radio Resource Provisioning) technology ensures the wireless infrastructure is always optimized to deliver maximum performance. Fortinet APs enabled with this advanced feature continuously monitor the RF environment for interference, noise and signals from neighboring APs, enabling the FortiGate WLAN Controller to determine the optimal RF power levels for each AP on the network. When a new AP is provisioned, DARRP also ensures that it chooses the optimal channel, without administrator intervention.
NEW QUESTION # 17
When using FortiPresence as a captive portal, which two types of public authentication services can be used to access guest Wi-Fi? (Choose two.)
- A. Software security token authentication
- B. Hardware security token authentication
- C. Short message service authentication
- D. Social networks authentication
Answer: B,D
Explanation:
This information along with the social network authentication logins with Facebook, Google, Instagram, LinkedIn, or FortiPresence using your WiFi.
Captive Portal configurations for social media logins and internet access. You can add and manage sites using the integrated Google maps and manoeuvre your hardware infrastructure easily.
NEW QUESTION # 18
When deploying a wireless network that is authenticated using EAP PEAP, which two configurations are required? (Choose two.)
- A. An X.509 to authenticate the authentication server
- B. 509 certificates and work for connections that use Secure Socket Layer/Transport Level Security (SSL/TLS). Both client and server certificates have additional requirements.
- C. A WPA2 or WPA3 personal wireless network
- D. An X.509 certificate to authenticate the client
- E. A WPA2 or WPA3 Enterprise wireless network
Answer: A,D
NEW QUESTION # 19
Which statement describes FortiPresence location map functionality?
- A. Provides real-time insight into user usage stats
- B. Provides real-time insight into user purchase activity
- C. Provides real-time insight into user movements
- D. Provides real-time insight into user online activity
Answer: C
NEW QUESTION # 20
Refer to the exhibits.
Exhibit A
Exhibit B
A wireless network has been created to support a group of users in a specific area of a building. The wireless network is configured but users are unable to connect to it. The exhibits show the relevant controller configuration for the APs and the wireless network.
Which two configuration changes will resolve the issue? (Choose two.)
- A. Disable intra-vap-privacy for the Authors vap-wireless network
- B. For both interfaces in the wtp-profile, configure vap-all to be manual
- C. For both interfaces in the wtp-profile, configure set vaps to be "Authors"
- D. Increase the transmission power of the AP radio interfaces
Answer: B,C
NEW QUESTION # 21
Where in the controller interface can you find a wireless client's upstream and downstream link rates?
- A. On the AP CLI, using the cw_diag -d sta command
- B. On the controller CLI, using the diag wireless-controller wlac -d sta command
- C. On the controller CLI, using the WiFi Client monitor
- D. On the AP CLI, using the cw_diag ksta command
Answer: B
NEW QUESTION # 22
Which factor is the best indicator of wireless client connection quality?
- A. Downstream link rate, the connection rate for the AP to the client
- B. The channel utilization of the channel the client is using
- C. The receive signal strength (RSS) of the client at the AP
- D. Upstream link rate, the connection rate for the client to the AP
Answer: C
Explanation:
SSI, or "Received Signal Strength Indicator," is a measurement of how well your device can hear a signal from an access point or router. It's a value that is useful for determining if you have enough signal to get a good wireless connection.
NEW QUESTION # 23
As standard best practice, which configuration should be performed before configuring FortiAPs using a FortiGate wireless controller?
- A. Set the wireless controller country setting
- B. Create a custom AP profile
- C. Create wireless LAN specific policies
- D. Preauthorize APs
Answer: B
NEW QUESTION # 24
Refer to the exhibits.
Exhibit A
Exhibit B
A wireless network has been created to support a group of users in a specific area of a building. The wireless network is configured but users are unable to connect to it. The exhibits show the relevant controller configuration for the APs and the wireless network.
Which two configuration changes will resolve the issue? (Choose two.)
- A. Disable intra-vap-privacy for the Authors vap-wireless network
- B. For both interfaces in the wtp-profile, configure set vaps to be "Authors"
- C. For both interfaces in the wtp-profile, configure vap-all to be manual
- D. Increase the transmission power of the AP radio interfaces
Answer: A,C
NEW QUESTION # 25
Which two phases are part of the process to plan a wireless design project? (Choose two.)
- A. Project information phase
- B. Installation phase
- C. Site survey phase
- D. Hardware selection phase
Answer: A,C
NEW QUESTION # 26
A tunnel mode wireless network is configured on a FortiGate wireless controller.
Which task must be completed before the wireless network can be used?
- A. The new network must be manually assigned to a FortiAP profile.
- B. The wireless network to Internet firewall policy must be configured
- C. Security Fabric and HTTPS must be enabled on the wireless network interface
- D. The wireless network interface must be assigned a Layer 3 address
Answer: B
Explanation:
A FortiGate unit is an industry leading enterprise firewall. In addition to consolidating all the functions of a network firewall, IPS, anti-malware, VPN, WAN optimization, Web filtering, and application control in a single platform, FortiGate also has an integrated Wi-Fi controller.
NEW QUESTION # 27
Part of the location service registration process is to link FortiAPs in FortiPresence.
Which two management services can configure the discovered AP registration information from the FortiPresence cloud? (Choose two.)
- A. AP Manager
- B. FortiSwitch
- C. FortiGate
- D. FortiAP Cloud
Answer: C,D
Explanation:
FortiGate, FortiCloud wireless access points (send visitor data in the form of station reports directly to FortiPresence)
NEW QUESTION # 28
When enabling security fabric on the FortiGate interface to manage FortiAPs, which two types of communication channels are established between FortiGate and FortiAPs? (Choose two.)
- A. Security channels
- B. Data channels
- C. Control channels
- D. FortLink channels
Answer: B,C
Explanation:
The control channel for managing traffic, which is always encrypted by DTLS. l The data channel for carrying client data packets.
NEW QUESTION # 29
Refer to the exhibit.
What does the asterisk (*) symbol beside the channel mean?
- A. Indicates channels that can be used only when Radio Resource Provisioning is enabled
- B. Indicates channels that cannot be used because of regulatory channel restrictions
- C. Indicates channels that are subject to dynamic frequency selection (DFS) regulations
- D. Indicates channels that will be scanned by the Wireless Intrusion Detection System (WIDS)
Answer: C
NEW QUESTION # 30
When deploying a wireless network that is authenticated using EAP PEAP, which two configurations are required? (Choose two.)
- A. An X.509 to authenticate the authentication server
- B. An X.509 certificate to authenticate the client
- C. A WPA2 or WPA3 personal wireless network
- D. A WPA2 or WPA3 Enterprise wireless network
Answer: A,D
NEW QUESTION # 31
What type of design model does FortiPlanner use in wireless design project?
- A. Predictive model
- B. Integration model
- C. Architectural model
- D. Analytical model
Answer: C
Explanation:
FortiPlanner will look familiar to anyone who has used architectural or home design software.
NEW QUESTION # 32
As a network administrator, you are responsible for managing an enterprise secure wireless LAN. The controller is based in the United States, and you have been asked to deploy a number of managed APs in a remote office in Germany.
What is the correct way to ensure that the RF channels and transmission power limits are appropriately configured for the remote APs?
- A. Create a new FortiAP profile and change the county code settings on the profile
- B. Clone a suitable FortiAP profile and change the county code settings on the profile
- C. Configure the APs individually by overriding the settings in Managed FortiAPs
- D. Configure the controller for the correct country code for Germany
Answer: B
NEW QUESTION # 33
......
Verified Pass NSE6_FWF-6.4 Exam in First Attempt Guaranteed: https://dumpscertify.torrentexam.com/NSE6_FWF-6.4-exam-latest-torrent.html
